INSTALLATION INSTRUCTIONS
7631 Instructions 5-30-14.doc
Page 1 of 4
2011 – Current Chrysler 300, Dodge Charger, Dodge Journey Factory
Display Radio Camera
(CTP, RE2, RE4)
(Kit # FLTW-7631)
NOTE: Requires Chrysler/Dodge dealer to activate; see below
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Camera
Hole Saw for camera mount
Chassis Harness
Power Harness
Display Harness with 22-pin connector
These Instructions with Template
Dealer Programmer Tool
Phillips Screwdriver
Center Punch
1/4’’ Drill Bit (if needed)
Power Drill
Wire Ties
Electrical Tape or Heat Shrink Tubing
Plastic Trim Removal Tool
Soldering Iron & Solder
(Recommended)
T-taps (optional)
Small grommet or Silicone (If needed)
Vehicle service manual (If needed)
Safety Precautions:
•
Work in well ventilated area that is clear of obstructions.
•
Secure vehicle with tire chucks in both front and rear of tires.
•
Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•
Wear safety goggles and snug fitting clothes.
•
Use tools only for their intended purpose and which are in good repair.
•
Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions.
IMPORTANT: Use of this camera with
the factory screen requires activation
by a Chrysler/Dodge dealer. See below
for Dealer Programming Instructions.
If possible, have the dealer “enable”
the camera option prior to installation.
