INSTALLATION INSTRUCTIONS
7603 Instructions 5-29-14.doc
Page 2 of 3
Step 4: Insert connector end of the Camera
Harness through the hole(s) you drilled.
RECOMMENDED: Protect Camera Harness from any
sharp metal edges by applying a small amount of
silicone caulk or a rubber grommet (shown below)
to any area that may come into contact with metal.
Step 5: Route Camera and/ or Chassis
Harness along existing wiring and secure
using Wire Ties or Electrical Tape.
IMPORTANT: Ensure harnesses move freely with
the trunk or liftgate.
Step 6:
Connect Camera Harness to supplied
Chassis Harness
. The optimal location for this
junction may occur at the top of the liftgate or
inner trunk edge.
Step 7:
Route Chassis Harness forward
. It
may be necessary to remove sill plates, pillar
covers, side panels, etc. Use a Plastic Trim Removal
Tool to avoid damage to trim pieces.
Step 8: Connect Power Harness male RCA
connector to RCA located on your Display.
Step 9:
Using a vehicle specific service
guide/wiring diagram and a multi-meter
verify 12v Ignition or Reverse power source.
Red wire of power harness connects to 12v+
Ignition or Reverse power and Black wire of
power harness to Black chassis ground nut or
wire.
RECOMMENDED
:
Solder wires and cover with
Heat Shrink Tubing or use T-taps as an optional
connection method.
Step 10: Connect Chassis Harness to supplied
Power Harness RCA and power plugs.
Step 11: Use Wire Ties or Electrical Tape to
secure Chassis Harness and Jumper Harness
RCA and power connections
.
Step 12
:
Coil any excess
Chassis Harness and
secure it to existing vehicle wiring with Wire
Ties or Electrical Tape.
Step 13: Test system.
Close trunk or liftgate and
clear all removed items from around the vehicle
before starting the vehicle. Next, shift into Reverse
and check radio display for the camera image.
