INSTALLATION INSTRUCTIONS
Park View Pro with Front Camera
(Kit # 5000-CA6)
•
NOTE: Do NOT discard the box as it will be used during calibration of
system at final steps.
Please read thoroughly before starting installation and check that kit contents are complete.
Troubleshooting recommendations can be found on last page.
Items Included in the Kit:
Tools & Supplies Needed:
4 mounting feet
3M surface prep-pad
Allen wrench
Front sensor
Speaker with volume control
Park View Pro module
Camera with mounting foot
Chassis harness for camera
Video/power harness
3M camera mount adhesive pad
Wire strippers
Wire cutters
Electrical tape
Zip ties
Plastic panel removal tools
Digital Volt Meter / BCM safe test light
Screwdriver
Socket set
Wrench
Safety Precautions:
●
Work in well ventilated area that is clear of obstructions.
●
Secure vehicle with tire chucks in both front and rear of tires.
●
Turn vehicle accessories OFF and ensure ignition key is in OFF position.
●
Wear safety goggles and snug fitting clothes.
●
Use tools only for their intended purpose and which are in good repair.
●
Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
5000-CA6 rev2 Instructions 3-1-19
Page 1 of 5
