INSTALLATION INSTRUCTIONS
9002-8838 Instructions 9-23-16.docx
Page 6 of 6
GS
Step 28:
Run Red 12v+ ignition wire of supplied
Chassis Harness to ignition controlled power point on
HVAC panel power point.
NOTE: Step 29 is for factory display radios only. If
using an aftermarket radio/display refer to step
17.
Step 29:
Splice Red power wire and the green trigger
wire from the chassis harness to Blue/Red wire on back
of power point. RECOMMENDED: Solder and cover with
heat shrink tubing or use T-taps as an alternate
connection method.
Step 30:
Plug the Chassis Harness RCA connector into
your aftermarket display.
Step 31:
If you are using a factory display radio, You
will need to have the radio programmed at the
dealership for the back-up camera to display.
Step32:
Plug in the 22—pin white connector to the
open connector on the back of the radio.
Figure 1
Step 33:
Connect White 22-pin Connector to radio
along with all remaining radio connectors before
reinstalling radio head unit and all trim removed.
Step 34:
Connect male RCA of camera into female
RCA of jumper harness and proceed to the Dealer
Programming Instructions (Included).
Dealer Programming Instructions
PARK VIEW REAR BACK-UP CAMERA
VEHICLE CONFIGURATION
Vehicle VIN must be updated with the sales code of the
added accessory in order to enable system functionality.
Using the DealerCONNECT website and the scan tool,
complete the procedure below:
A.
Log on to https://dealerconnect.chrysler.com
B.
In the “Vehicle Option” screen under “Global Claims
System” category in the “Service” tab, enter the
VIN and add the following sales code: XAC (PARK
VIEW REAR BACK-UP CAMERA) as a “Dealer
Installed Option.”
C.
Confirm that the new sales code has been
successfully added to the VIN. With the scan tool
connected to both the internet (via Ethernet port or
wireless connection) and the vehicle, perform the
following steps:
D.
Using the scan tool, select VEHICLE PREPARATION
and then select RESTORE VEHICLE
CONFIGURATION.
E.
Follow the step-by-step instructions on the scan
tool to complete the Park View Rear Back-Up
Camera vehicle configuration.
Step 35:
Test the system. Start vehicle and shift into
Reverse in order to check that all connections were
made properly. If all of the connections are correct you
will see the camera image displayed on your aftermarket
display.
Step 36:
Reassemble vehicle. Follow your disassembly
steps in reverse order, taking care not to bind the
harness wiring when reinstalling trim.
