INSTALLATION INSTRUCTIONS
9002-8838 Instructions 9-23-16.docx
Page 3 of 6
GS
Install Chassis Harness
Step 5:
Plug the Camera connector into the gray
Chassis Harness connector, and insert RCA connector
end of supplied Chassis Harness through the rear gate
vent behind tire carrier.
Step 6:
Using a plastic trim removal tool, remove
interior panels on inside of rear gate.
Step 7:
Pull harness through the rear gate openings.
Step 8:
Use supplied Wire Ties to secure Chassis
Harness to existing harness.
Step 9:
Use supplied Wire Ties to secure Chassis
Harness to fabric factory wire cover. CAUTION: Leave
enough slack to allow gate to open fully.
Step 10:
Use a T20 Torx bit to remove subwoofer box.
Step 11:
Using a plastic trim removal tool, pry off rear
seat belt closeout.
