INSTALLATION INSTRUCTIONS
Programing Instructions
PLEASE NOTE: These modules are VIN locked for
single use.
1) Start the vehicle. Allow it to run for 20-30 seconds
before proceeding to step 2.
2) Plug module into OBDII port, located under the
dash on the driver’s side, and wait to see a
GREEN LED on the module. Programming is
completed.
3) Unplug the module from the OBDII port. DO NOT
DISCARD.
Step 35: Test the system. Start vehicle and shift into
Reverse to check that all connections were made
properly. If all the connections are correct, you will see
the camera image displayed on the factory display
screen.
To enable or disable the camera input, select
from among rear vision options in radio settings.
9002-8817 Instructions
Page 7 of 7
