INSTALLATION INSTRUCTIONS
Step 25: Remove center stack/cluster surround.
Step 26: Remove glove box for access and run Chassis
Harness toward the center of the dash.
Step 27: Using a plastic trim removal tool, remove
HVAC panel.
Step 28: Run Red 12v+ ignition wire of supplied
Chassis Harness to ignition controlled power
point/cigarette lighter below HVAC panel.
Step 29: Splice Red power wire and the green trigger
wire from the chassis harness to Blue/Red wire on back
of power point/cigarette lighter. RECOMMENDED: Use
solder and cover with heat shrink tubing or use T-taps
as an alternate connection method.
Step 30: Plug the Chassis Harness RCA connector into
your aftermarket display.
Step 32: Plug in the 22-pin white connector to the open
connector on the back of the radio.
Figure 1
For reference only
Step 33: Connect all remaining radio connectors before
reinstalling the radio head unit and all trim removed.
Step 34: Connect male RCA of camera into female RCA
of jumper harness and proceed to the Dealer
Programming Instructions.
9002-8817 Instructions
Page 6 of 7
