INSTALLATION INSTRUCTIONS
9002-8808.docx
Page 6 of 6
JM
Step 28:
Mount the 2 pieces with the lock down bar to
the spare tire carrier. Run the camera wire through the
opening of the spare tire.
Step 29:
Connect to 4-pin connectors together inside
the tire carrier by reaching around the spare tire.
Step 30:
Make sure tire lock down bar is in the correct
location.
Step 26:
Test the system. Start vehicle and shift into
Reverse in order to check that all connections were
made properly. If all of the connections are correct you
will see the camera image displayed on your aftermarket
display.
Step 27:
Reassemble vehicle. Follow your disassembly
steps in reverse order, taking care not to bind the
harness wiring when reinstalling trim.
Step 31:
Reassemble vehicle. Follow your disassembly
steps in reverse order, taking care not to bind the
harness wiring when reinstalling trim.
