INSTALLATION INSTRUCTIONS
9002-2775 v2 Instructions 7-28-16
Page 2 of 4
JM
1.
Remove the dash trim to gain access
to the screws that mount the screen
into the dash.
2.
Remove the 4 screws that hold the
screen into the dash.
3.
Remove screen and the 2 harnesses
connected to the back of it. Set
aside in a safe place.
4.
The round connector on the back of
the screen is the LVDS video
connector.
5.
The square connector on the back of
the screen is the CAN/power
connector.
6.
Plug the male LVDS harness from
the 9002-2775 kit into the factory
plug.
7.
The other end or the harness will
plug into the interface module
labeled LVDS out.
8.
Connect the factory LVDS connector
9.
Plug the male end of the T-harness
of the 9002-2775 into the
power/Can connector on the factory
screen.
10.
Plug the factory plug into the female
connector on the T-harness from the
9002-2775.
11.
Connect the RED wire to accessory.
Accessory can be found at the
power point or in the kick panel
area.
12.
Connect the BLACK wire to ground.
13.
Connect the PURPLE wire to a switch
to trigger the front camera input on
to a turn 12 volts to trigger
a blind spot camera.
14.
Connect the ORANGE wire to the
reverse wire +12 volts (only if the
interface is not triggering through
CAN.)
15.
Connect the BROWN wire and
BROWN/RED wire in the
passenger/driver kick panel.
(They
are Hi and Lo CAN wires and will
match the wire colors in the vehicle
at the CAN HUB or twisted wires on
their own.)
