Branach FEU-FC, User Instructions

Page: 6 / 92

FIGURE 2F.
Ladders used for access to a higher level shall
be extended at least 1 metre above the landing point and
secured if necessary.
FIGURE 2G. Only use the ladder in the direction indicated.
FIGURE 2H.
Do not lean the ladder against unsuitable
surfaces. For pole work use a Branach Pole Strap or
Pole Chain combined with a Top Lash.
FIGURE 2I. Do not stand on the top 3 steps/rungs of
a leaning ladder.
FIGURES 2J.
Ensure the latch has fully engaged the rung
when extending the ladder. If the latch is not parallel with
the ladder, adjust so it is engaged fully.
TerrainMaster
■
Always use with TerrainMaster feet in an open position.
FIGURE 2K.
Do not exceed the level the TerrainMaster
can operate in (15° slope). Use the built-in level bubble or
spirit level to ensure the platform ladder steps are level.
Positioning and Erecting the Ladder
■
The ladder should be extended with the rungs or
treads level with the ground.
■
The ladder must be erected on a firm, unmovable
surface with a maximum gradient of 15°.
■
When positioning the ladder, take into account the
risk of collision with the ladder (e.g. from pedestrians,
vehicles or doors).
■
Identify any electrical risks in the work area, such as
overhead lines or other exposed electrical equipment.
■
The ladder should be stood on both feet; not supported
on the rungs or steps.
■
Ladders should not be positioned on slippery
surfaces — such as ice, shiny surfaces or significantly
contaminated solid surfaces — unless additional
effective measures are taken to prevent the ladder
slipping or ensuring contaminated surfaces are
sufficiently clean.
04