PCI LPT & RS232
Specifications
Chapter 2 Page 13
STEP 6: Now replace the system units cover by carefully sliding
it down and back over the system unit. Replace the cover
mounting screws.
STEP 7: After attaching all the monitor and keyboard cables,
power up the PC. Do not forget the mains power cable!
The PC should power on in the normal way.
Problems!
If the system fails to power up normally check the following.:
i.)
Ensure that the PC Serial card is installed correctly.
ii.) Ensure that other cards in the PC have not been upset.
iii.) Ensure that the power is connected and the PC is switched
ON!
n
If all these have been checked and the PC still does not
power up then there is probably a conflict of I/O address between
the PC Serial card and another board in the PC. Ask your dealer to
check this
Installing Serial Port 2.
On the ribbon cable of the fly lead, an individual wire is
coloured, which leads to the male connector, at which point it
terminates, below that point is an inverted triangle - this indicates
the Pin # 1 of the serial port. Making sure the Pin # 1 marking on
the plug aligns with the Pin # 1 marking next to the serial header
press the plug down evenly and firmly, until resistance is felt - the
serial port has been plugged in. It is then mounted on a bracket
allowing it be placed in a spare PC aperture. Figure 2-6, below,
indicates this.
