21
V4.0419
•
Content Subject to Change
O
PERATION
D
OUBLE
S
CRUBBING
(M
ANUAL
M
ODE
O
NLY
)
Double scrubbing is a mode of operation in which the machine scrubs the fl oor without simultaneously
removing the fl uid from the fl oor’s surface. The squeegees and vacuum are not engaged during double
scrubbing, only the scrub brushes/pads. This allows the cleaning solution to remain on the fl oor longer for a
deeper clean.
NOTE:
DOUBLE SCRUBBING IS FUNCTIONAL IN MANUAL MODE ONLY AND SHOULD ONLY BE USED IN A
CONTROLLED ENVIRONMENT WHERE THERE IS NO POTENTIAL FOR SLIPPING AND FALLING.
Perform the following steps to perform double scrubbing:
1. Fill the solution bottle and clean water tank.
2. Sit on the operator seat and turn on the machine
using the ignition key.
3. Press the up arrow of the directional switch.
4. Press the One-Touch button, which engages
the cleaning components (scrub brushes/pads,
squeegees, and vacuum). The One-Touch button’s
light will illuminate.
5. Press the Vacuum button to turn off the vacuum.
Doing this also raises the squeegees off the fl oor.
6. Drive the machine along the desired route for
double scrubbing.
7. Let the cleaning solution set on the fl oor for
approximately 5 minutes.
8. Press the One-Touch button to inactivate the
scrub brushes/pads and solution fl ow.
9. Press the Vacuum button to turn on the vacuum,
which also lowers the squeegees to the fl oor.
10. Drive the machine along the same path to pick up
the cleaning solution.
*
Drive in a straight path as much as possible.
*
Drive slowly on inclines, declines, and slippery surfaces.
*
Avoid inclines or declines greater than 2% when operating manually.
*
Maintain a safe distance of approximately 18 in (46 cm) from the edge of ramps, platforms, cliffs, and
glass.
*
Avoid sudden turns and/or turning the steering wheel too sharply when driving.
*
Use caution when driving backward.
*
Report any damage to the machine prior to operation.
