SDI-MS16 Video Switcher
Operating manual
4
BRÄHLER Systems GmbH
Auf der Alten Burg 6
53639 Königswinter
Germany
T +49 (0)2244 930-0
F +49 (0)2244 930-450
www.braehler-systems.com
07.3786 191004 V1.01 BRÄHLER Systems is committed to continually improving its products and so reserves the right to make technical modifications without notice.
By default the video switcher receives an IP address from the DHCP server within your network.
Both brählerOS and CamControl2 will then be able to detect the video switcher automatically and
identifies its IP address. If you have trouble in identifying the video switcher in the software, please
make sure, that the IP address and subnet mask of the switcher is properly configured and matches
with the control PC settings.
The video switcher is now ready for use and switches the video inputs according to the currently
active microphone. If you want to use additional outputs for e.g. preview monitoring, please
configure the outputs manually.
Optionally, you can connect a camera controller to the video switcher to adjust the cameras
during live operation. (Please refer to the corresponding manufacturer's manual for
information on operation.)
Operation
Operation
Operation
Operation
Set the video switch on/off switch to "on" to turn on the unit. The front panel display will light. Now set
which input is to be switched to which output. First press the "IN" button of the video switch and then the
desired input (1-16). Now press the "OUT" button and select the output channel (1-16) by pressing the
corresponding button. The camera image can now be viewed on the connected screens. The display
shows to which output the respective input is connected.
Switching an input to multiple outputs: press buttons “IN; 1” an buttons “OUT; 1; 2; 3; 4” (for example).
The OUT button indicator will automatically close after 8s. When it is off, you only need to press
the OUT button again to continue the unperformed switch.
The CamControl 2 software determines which camera image is actively placed on the main output and
thus displayed.
By turning and pressing the control wheel on the front of the video switch you can set the basic settings
of the device. By pressing the wheel you reach the main menu. Here you have the following options:
System Setting
Network setting
Output setting
Device Info
Exit
By turning the knob you go to the corresponding menu point - by pressing you select it and change it.
