7
Express® Lavatory System SS-Series
Installation - Obsolete
SS-3/BIR/WH97TAS
Bradley Corporation • 215-1469 Rev. B; EN 08-805
4/24/08
Installation Instructions continued . . .
Step 2: Mount frame to wall
1. Using a T25 bit, remove the nine Torx-head screws securing the panel to the frame and
remove the panel (see Figure 3).
2. Attach the battery box brackets to the frame at three places using the #10-24 screws and
washers provided (see Figure 4).
NOTE: If a single tempered supply line is to be used, the supply line and valve parts should be
connected at this time. Refer to the installation instructions and Figure 7b found on page 11.
3. Position the frame against the wall, ensuring that it is level.
IMPORTANT: Anchoring the frame to a wall that is not flat may cause the frame to
bend. If necessary, install shims to compensate for wall distortion.
4. Ensure that the back of the frame is flat against the wall. If wall is not flat, insert shims
behind the frame to ensure that it will not bend when anchored.
5. Once you have positioned the frame such that it is level and flat against the wall or shimmed,
use the 3/8" bolts and washers to mount the frame to the wall (see Figure 4).
Figure 3
(9) TORX-HEAD SCREW
(bit size T25)
FRAME
PANEL
Figure 4
BOWL AND
SPRAYHEAD
SHOWN FOR
REFERENCE
ONLY
