S59-4007
Installation
2
2/1/2018
Bradley
• 215-1852 Rev. C; ECN 18-09-011
WARNING
Failure to comply with proper installation and maintenance instructions could contribute to the valve failure
resulting in severe bodily injury including scalding, chilling, and/or death depending upon system water
pressure changes and/or supply water temperature changes.
Use this Thermostatic Mixing Valve in accordance with ASSE standard 1070. This valve does not provide
protection from pipe freezing.
Output temperature of the valve must be checked and adjusted at initial installation and on a quarterly basis.
Make sure that all water supply lines have been flushed and then completely turned off before beginning
installation. Debris in supply lines can cause valves to malfunction.
NOTICE
Regular checking and cleaning of the valve’s internal components is necessary for maximum life and proper
product function. Periodic inspection and yearly maintenance by a licensed contractor is required. Corrosive
water conditions, and/or unauthorized adjustments or repairs could render the valve ineffective for its
intended service. Frequency of cleaning and inspection depends upon local water conditions.
IMPORTANT
Read this entire installation manual to ensure proper installation. When finished with the installation, file
this manual with the owner or maintenance department. Compliance and conformity to local codes and
ordinances is the responsibility of the installer.
Consult local building and plumbing codes prior to installation. Should these codes differ from the
information in the Manual, follow the local codes. Inquire with governing authorities for additional local
requirements.
Separate parts from packaging and make sure all parts are accounted for before discarding packaging
material. If any parts are missing, do not begin installation until you obtain the missing parts.
Product warranties may be found under “Products” on our web site at bradleycorp.com.
Supplies Required
• Shut-off on the outlet if tempered water is
supplied to a remote location
• Shut-off on the inlets/supplies
• (2) #10 fasteners (and wall anchors, if
necessary) for wall bracket
Tools Required
• Adjustable Wrench
• Needle-Nose Pliers
• Phillips-Head Screwdriver
