Position flanges and mark
hole locations on the floor.
Remove the bench.
Using a 1/4" masonry drill bit,
drill starter holes in the floor
1-1/8" to 1-1/4" deep.
C
D
Insert a stud, thread side up, into each hole.
Place a washer and nut (flush) on top of the
stud and tap on the nut with a hammer until
seated.
Tighten nut to secure bench(es).
Installation
Lenox Lockers™ Pedestal Bench
3
Bradley Corporation • LK-INSTR-003 Rev. A; EN 06-1309
9/29/06
6"
(152mm)
C
L
Position each pedestal on the
underside of the bench.
Mark the hole locations and
remove the pedestals.
Using a 3/16" drill bit, drill 1/2"
deep starter holes in the bench.
A
B
Secure the pedestals with the
#14 x 1-3/4" screws provided.
Pedestal To Bench
Bench to Floor
Installation
