4. OPERATION INSTRUCTIONS
1. Open housing with included security key.
2. Open cover on battery compartment, remove battery box and unplug cable.
Install four (4) new Alkaline Type AA 1.5V batteries with correct polarity
(note the +/- indication) to obtain 6V DC ± 10% at the plug.
3. Reinstall battery box and close compartment cover.
4. Remove, clean out and refill the included reusable soap reservoir with foam soap,
ensure that soap container cover is closed, air vent hole is open and nozzle is not clogged.
The soap container should be clean (no spill over) and not leaking. Install the reusable reservoir
into the dispenser. Make sure the nozzle flange is below the housing cradle rib to stretch the
valve tube.
5. Make sure to latch the cradle gate.
6. Close the housing cover and lock it with the included security key previously retained.
7. Observe that the LED light is blue and then flashes four (4) times. This indicates that
the environment has been detected.If there is no object under the dispenser,
the default sensing distance is 3.15" to 3.93" (80mm to 100mm). If there is an object
(such as a basin or counter)under the dispenser, the sensor will detect the installation
height and environment light to set a suitable sensing distance automatically.
8. Trigger the sensor with hands or a towel to check proper soap dispensing cycle .
6. BATTERY LOW INDICATION
With housing cover open and soap reservoir removed
(see Instructions) perform the following diagnostic test:
1.Press and push up the cover safety interlock switch
(blue stem) on bottom to click and hold it.
2.Observe that the LED
3.If LED continue
s
positive to replace the batteries.
is lit blue and then flashes
four (4) times indicating proper operation “stand-by”
condition and battery charge level.
s to flash blue the indication i
1. Ensure no bright source is aimed or reflected at the
sensor from below.
2. Use fresh new foam soap only and clean the soap
container properly before each re-fill. Deposits of old
soap will lead to malfunction and jamming.
3. Do not dilute foam soap unless concentrate and do not
use soap containing abrasive. Observe indicated
viscosity factor of foam soap.
4. Do not immerse the soap dispenser in water or clean it
under running water. This will lead to short circuit.
5. Should the dispenser be out of order and batteries have
been replaced, do not attempt any repair work. Call your
dealer for professional assistance.
5.IMPORTANT NOTICE
AA (1.5V)
Caution : Batteries installed with incorrect polarity may cause malfunction.
7. Diagram
Base plate
Soap tank
Key
Lock
Spout nozzle
Valve pump
Tank cover
Cover
Electronic box
Battery box
Nut
Hinge nut
Hinge screw
Retainer
screw
2
8. Provided in kit
1. Key x 1
2. Plastic Anchor x 4
3. Mounting Screw x 4
4. Mounting Template x 1
5. Self-adhesive Tape x 3
