background image

2

Bradley TouchTime

 Individual Built-In Wall Shower with Concealed Supplies

 Installation

1/9/2014 

Bradley • 

215-1152 Rev. E; ECN 13-03-022

A

B

C

Rough-in tempered water supply 
piping to the solenoid valve as 
required for your installation .

Rough-in wall openings for the 
showerhead and pushbutton as 
required for your installation .

Install two #10 wall 
anchors (supplied 
by installer) to 
secure pushbutton 
assembly .

Pre-Installation Information

Supplies Required for Installation

• 

1/2" IPS piping and 1/2" IPS tempered water supply piping and fittings (for solenoid)

• 

four 1/4"-20 wall anchors for showerhead and two #10 wall anchors for pushbutton assembly

• 

Teflon tape or teflon pipe dope

• 

110 VAC power source for 24 VAC Class II transformer or 110/24 VAC Class II transformer (available from 
Bradley as an option)

Operation

The 1C Touch Time Shower controls water flow at each station through the use of solid state circuitry . When the 
pushbutton is released, a signal is sent controlling the opening and closing of the fixture's solenoid valve . The valve 
then delivers water to the fixture for a preset length of time (60 seconds or 180 seconds) .

Recommended showerhead heights

Bradley 1C TT showers can be installed at any height (see 
recommended heights below) . 

NOTE: The heights listed below 

are measured from finish floor to showerhead tip.

Components

Material:

 All exposed parts are stainless steel or polished chrome-plated brass . 

Supply Inlet:

 The supply inlet to the solenoid valve is 1/2" IPS . 

Solenoid Valve:

 Solenoid valves have few moving parts making them less prone to mechanical failure .

Rough-in

IMPORTANT:  Your 1C TT Shower must be connected with a 24 VAC transformer power supply. Connection to 

110 VAC will result in damage to the electronics and could result in personal injury.

IMPORTANT:  Refer to recommended shower heights shown above.

Solenoid Valve

Solenoid Valve

2-7/8" 

(73mm)

16" 

(406mm)

2-7/8" 

(73mm)

4-1/4" 

(108mm)

2-3/8" (60mm)

1/2" (13mm)

1-1/2" (38mm)

3" (76mm)

5-7/8" 

(149mm)

2-1/4" (57mm) 

diameter

1/2" Supply Inlet

1/2" IPS Piping 

(supplied by installer)

(2) #10-24 Screw 

(supplied by 

Bradley) and 

(2)#10 wall 

anchors (supplied 

by installer)

Reducer

Inlet

Outlet

Showerhead

Escutcheon

(4) 1/4"-20 Anchors (supplied 

by installer) and (4) screws 

(supplied by Bradley)

Age

Male

Female

Adult

6' (1 .83m)

5'6" (1 .68m)

Teenage

6' (1 .83m)

5'6" (1 .68m)

Pre-Teen

5'6" (1 .68m)

5'6" (1 .68m)

Reviews: