Picture 2
Picture 1
MVM MODIFICATION INSTRUCTIONS
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Before you begin to form your MVM, please make sure it looks exactly
the way it does in the top picture.
To being, use a marking pen to draw a line on the MVM as
depicted in red in the middle picture to the left.
Note:
See red
lines in middle picture for guidance.
Use tin snips to cut along this line. When this line has been
made completely, continue by bending along the yellow line as
depicted in the middle picture. You will need to make this bend a
90° angle. If the bracket gets bent or the paint chips, use a small
hammer to pound out the imperfections, then a black paint to
cover up the paint.
Now go back to
step3
on the previous page to fi nish installation.
5
6
7
The Bracketron MVM-35-05 mount is a modifi able mounting bracket. The illustrations on the left show how this mount should
look during and after the modifi cation steps in order to fi t the listed vehicles on the front page of this manual.
Many vehicle
applications may not require any modifi cations to the mount. If this is the case it will be noted below and there will be no steps
to follow on this page.
PLEASE NOTE
Cut Mount Here
Picture 3
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
Bend Mount Here
