IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers
seat vantage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic
parts of a vehicles dash.
WARNING:
Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED:
MVM-35-05 Mount, 3 - #8x3/4” Self Tapping Screws PHS-203 Ultra Slim Swivel and Hardware.
TOOLS NEEDED FOR MVM MODIFICATION
(
if required
)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Small File
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
Ford Radio Removal Tool (Part #SIT-101)
9/32” Socket and Rachet
Utility Knife
9/32” Open End Wrench (for swivel)
Marking Pen
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Locate four holes on the face of the radio. There are two holes on the
right and two holes on the left. Insert the DIN tools (part #SIT-101) in
these holes until you feel and hear a click. Apply pressure on the DIN
tools towards the left and right while simultaneously sliding the radio out
of its cavity.
Carefully
remove the wiring on the back of the radio and
set aside. Locate two screws in the inside top area of the radio cavity.
Remove these screws with the 9/32” socket and rachet. With your hand
and fingers, grab the lower right corner of the dash bezel and carefully
pull toward you releasing the lower right clip. After that clip is loose,
carefully grasp the lower section of the trim bezel on the left and right of
the climate control. Slowly pull towards you releasing two clips. Grab the
top right corner of the bezel and pull toward you releasing the top right
clip. Slowly work the top clips loose all the way to the left of the steer-
ing wheel. Work the lower clips loose for a total of 13 clips.
Tip:
Apply
the emergency brake and place the gear shifter in low gear, then tilt the
steering wheel in low position. When the bezel is loose, disconnect all the
wiring, remove the bezel and place it in a safe place.
Skip to
Step 5
on the following page if you have not yet formed the
bracket to fit your vehicle.
Carefully trim the dash in location as shown in the picture to the left. With
the 9/32” socket and rachet, remove the four screws that hold the climate
controls in place.
Note:
Do not disconnect any wiring to the climate con-
trol. Place MVM in location as shown behind the climate control (lower
left screw hole).
Carefully reinstall the dash in reverse order securing all screws and clips
to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi
Vehicle Mount or any other AMPs compatible device.
Your installation is complete
Trim dash here
1
2
3
4
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
Install Mount Here
