Bpt AG2K200C03UK, Installation Manual

Page: 7 / 12

Targha 200
TAR
GHA 200
7
ASSEMBLY OF THE BUTTON
Push the front plate from the front to release the hole
plug (fig. 1) and subsequently remove it. Insert the but-
ton as illustrated in fig. 2 and 3. Apply the spring to the
button (fig. 4). The name card can be removed and filled
in with the relevant information by removing the card
clip followed by the actual card itself (fig. 5). Personal-
ized name cards can be used up to a maximum of 2 mm
thick.
CLOSURE OF THE COVER PLATE
In order to fit the front plate, first insert the upper part
in the top moulding and then, using a Allenkey s 2.5,
tighten the lock screw (fig. 1-2).
1 2
3
4
5
1
2
5
21
8
11
12
14
5
21
8
11
12
14
2
A
1 3
4 5 6
SIDE-BY-SIDE RECESSED INSTALLATION
For horizontal (fig. 1-2) or vertical (fig. 3-4) combinations, remove the hole plugs and insert the cable guide joints. Fit the spacer into embedding boxes to avoid deformation
(fig. 2-4).
SIDE-BY-SIDE WALL INSTALLATION
For horizontal combinations, insert the two hole plugs on the outside, at the bottom inside the cable guide joint and top inside the joint (fig. 5).
Fasten the bases to the wall using the screws and screw anchors supplied (fig. 6).