Bpt AG2K200C03UK, Installation Manual

Page: 4 / 12

4
A/200N
A/200n
A/200N
43,5
45
7,5 57
105
106
A
B
64,5 105
14
5
1
2 3
1
2
3
4
INSTALLATION
• The power supplier must ALWAYS be installed horizontally.
• The device can be installed on a DIN rail (EN 50022) in an appropriate electric panel or it may be wall-mounted using
the protective terminal covers.
• For disassembly, proceed as shown in figure 2-3-4.
• For the overall dimensions see figure 1.
NOTE. Proper ventilation is required if the power supplier is installed in a metal container.
OPERATING CHARACTERISTICS
The unit is equipped with a transformer capable of powering the HPC/1 entry panel and max. 20 HPP/6 panels.
The unit features the following functions:
- 2 two-tone call notes for entry panels (or for supplementary calls, e. g. landing calls).
- Power supply and control of electric lock (12 V AC, 1 A) by means of relay (inside the unit) with timer-controlled interval adjustable from 2 to 15 seconds by means of poten-
tiometer P1, figure 3.
-Call generator: 2 types of two-tone call (up to 3 internal units can be connected in parallel to the same call).
The unit can be powered from a 12 V DC power supply, e. g. battery or uninterruptable power supply (terB and 5). The unit has no battery protection.
A
5 8
+B 5 21 8 8A 11 12 23 16 NO C NC
9
B C
P1
TERMINAL BOARDS
A
~
Mains
~
B
+B
5
12 V DC input (*)
Ground
21
11 V DC output
8 call common 1 output
8A
call common 2 output
11 audio from entry panel
12
audio to entry panel
5 –
output 14 V AC
6 +
NO Normally open
relay
contacts
C common
NC
normally closed
C
5
ground
8
Audio to receiver
9
Audio from receiver
(*) The appliance is electronically protected against
overloads and short circuits.
TECHNICAL FEATURES
Supply voltage 230 VAC 50÷60 Hz
Rated power 34 VA
Output voltages
11 VDC, 150 mA
14 VAC, 650 mA
Peak output voltages 300 mA
Operating output voltages 1A
Dimensions 4 DIN
Storage temperature -25 °C +70 °C
Operating temperature 0 °C +35 °C
IP Degree IP 30