10
Cassette encoding
1.
Set the function button to TAPE/AUX mode and then insert a memory device (USB
drive, SD or MMC card).
2.
Press the record
REC button, it will take 3 - 4 second to read the memory device,
then the USB or SD icon will be flashing on the LC display.
3.
Press the skip up
or skip down
button to select the desired mode (USB
or SD) for encoding, then press the record
REC button again to confirm.
(You can skip this step if only a USB drive or an SD/MMC card is inserted.)
4.
The system will start the encoding mode after a few seconds. Insert your cassette into
the playback slot. During encoding, the USB or SD icon will be flashing on the display.
5. To finish encoding, press the stop
button. The display will show “END” and return
to TAPE/AUX mode.
NOTE
:
The recording format is preset at MP3 bit rate 128 kbps.
The recording speed is 1:1. Recording will take as long as playing the record.
CD Operation
1.
Turn the volume knob clockwise to turn the equipment on.
2.
Press the CD-Rom switch ,then the disk tray door opens .
3.
Place the CD face up inside ,making sure it is fully placed .Then press the CD-Rom
switch again ,the disk tray door closes .
4.
To play a different piece on the record, Press the skip up
or skip down
button to select the desired piece.
5 To adjust the volume level, turn the volume knob to the right or left.
CD encoding
1. Set the function button to CD/USB/SD mode and then insert a memory device
(USB drive, SD or MMC card).
2. Press the record
REC button, it will take 3 - 4 second to read the memory
device, then the USB or SD icon will be flashing on the LC display.
