37
This function turns the Projection Lamp off when the projector
detects signal interruption and is not used for a certain period. This
reduces power consumption and helps extend Lamp-life. (This
projector is shipped with this function ON.)
This function operates as follows;
1. When the input signal is interrupted, a “No signal” message
and 5 minute count-down are displayed.
2. When the count-down is complete, The Projection Lamp and
READY Indicator are turned off. (Cooling Fans keep running.)
3. The READY Indicator starts to flash after the cool-down
sequence is complete (about 90 seconds)
The Projection Lamp will be turned on automatically when an
input signal is connected or if any button on the Top Control or
Remote Control is pressed.
Power management
This function is used to reset the Lamp Replace Counter. When
replacing the Projection Lamp, reset the Lamp Replace Counter
using this function. Refer to page 38 for operation.
Lamp counter reset
Remote control
This projector has eight different remote control codes; the factory-
set normal code (Code 1) and seven additional codes (Code 2 to
Code 8). This switching function allows several projectors in the
same area to be controlled via remote control without interfering with
each other.
For example operating projector in “Code 7,” both projector and
Remote Control must be switched to “Code 7.”
To change the code of Projector;
To change the Remote control code of the projector use the ON-
SCREEN MENU to select from Code 1 to Code 8.
To change the code of the Remote Control;
To change the remote control code of the Remote Control, set the
DIP switches 1-3 inside the battery compartment box of the Remote
Control. (Refer to P14.)
On start
When this function is “On,” the projector will turn on automatically
when it is connected to AC Power.
Note ; Be sure to turn the projector off properly (refer to the section
“TURNING OFF PROJECTOR” on P19). If the projector is
turned off incorrectly, the On Start function may not operate
properly.
Time left until Lamp off.
Press SELECT at this icon to display
other items.
SETTING
Lamp mode
When selecting the "
" (Eco) mode, the projector reduces the
brightness of the lamp and reduces the cooling fan speed to
conserve power and extend lamp life.
When pressing SELECT at Remote
control, Remote control code Menu
appears.
Move the pointer to the item and
then press POINT LEFT/RIGHT.
Press SELECT at this icon to display
previous items.
On
Code 1
On
On
Code 1
On
Remote control