Add or delete (handsets) remote controllers
To add additional remote controllers push and hold the “P” button, until the
number 7 LED flashes.
Press the required button on the extra hand-held remote control for 3 seconds,
then press the same button again. Lamp no. 7 will flash again to confirm the
programming. Press “P” to finish, and lamp 3 will light up continually. Repeat the
above for encoding more remote controllers.
To deleted handset codes
Press and hold “P” button until the 7 LED flashes.
Press and hold the “-“ button for 3 seconds.
The code memory has been cleared. All hand held remotes (handsets) will no
longer operate the door opener.
Replacing battery in remote control
Caution!
• Incorrect battery replacement can be dangerous. Always replace with the
same battery type.
• Use longlife batteries.
• Slacken screws on rear of remote control and remove cover.
• Replace battery.
• Check alignment of poles (+/-). Place - pole on spring
• Replace cover and tighten screws.
Maintenance and inspection
Perform following safety check before first use and at least once a month.
Place an object of at least 40 cm height in door opening
Activate door closure. When the bottom of the door touches the object, the door
should stop and open completely.
If it fails to do so, contact Millarco’s service department.
Disconnect from mains before working on machine.
The machine is designed to operate problem-free for long periods of time with a
minimum of maintenance. By cleaning the machine regularly and treating it
correctly, you prolong service life.
The product must be cleaned and rail greased at regular intervals.
Activate door under observation at regular intervals to check for faults. Check all
nuts and bolts.
