Heater may not be placed directly below the socket.
Heater may not use program, controller, timers or other device to automatically connect heater.
The instructions for heaters marked “Do not cover” or with the “Do not cover” symbol shall contain
the substance of the following:
WARNING: In order to avoid overheating, do not cover the heater.
Do not use this heater in small rooms when they are occupied by persons not capable of leaving
the room on their own unless constant supervision provided.
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the
appliance provided that it has been placed or installed in its intended normal operating
position and they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children aged from 3 years
and less than 8 years shall not plug in, regulate and clean the appliance or perform user
maintenance.
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
CAUTION
—Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are present.
This product has tie type "Y". If the cord is damaged, it must be replaced by the manufacturer or its
service agent or qualified personnel to avoid risk.
Danger: You should not repair the appliance by yourself. It must be done just by qualified
specialists.
Only original spare parts may be used for repair.
To unplug before to touch the sockets.
ASSEMBLY
1. Assemble the body frame and the base plate together as the following sequences. Remove the
mounting screw from the lower part of the body frame.
2. Insert the power cord through the slot placed in the middle part of the basement and then
assemble the body frame to the base plate.
3. Secure the body frame to the base plate by means of the two mounting screw previously
removed. Insert the power cord through the suitable slots and then fix it by the clamp.
COMPONENTS
1-Body frame
2-Base plate
3-Butterfly (2 pcs)
4-Tip-over safety switch rod
5-Power cord guide
6-Power cord
