1
2
1
2
3
3
4
Clean the area of the glass plate
where the tablet case is to be
mounted with the 3M cleaner sachet.
Place the acrylic plate leveled and in the
desired position on the glass plate.
Mark the top and one of the sides with
standard office tape or likewise.
Place the tablet case leveled and in the desired
position on the wall.
Mark the four VESA
holes on the wall
with a pen.
Remove the tablet case.
Pre-drill and insert
rawplugs if needed.
Use a M5 metal drill to open up the
four VESA holes marked inside the
tablet case.
The BOX IT Glass Plate
Mounting kit:
The BOX IT Standard Wall
Mounting kit:
Remove the four cover pieces
from the 3M tape at the back
of the acrylic plate.
Wait for minimum 24 hours before
mounting the tablet case to the
acrylic plate using the four M4x8 mm
screws.
4xM4x8 mm
Torx TX20 tool
3m VHB surface
cleaner sachet
Premium Tablet Case
Premium Tablet Case Acrylic plate with
3M 4910F VHB tape
Charging cable
Office tape
Charging cable
entry hole
entry
hole
entry hole
D
E
S
I
G
N
O
www.boxit-design.com
Place the acrylic plate onto the glass
at the tape markings. Press hard and
remove the office marking tape.
If using a charging cable: Pull it through
the groove in the acrylic plate and through
one of the entry holes ensuring enough
cable length for the tablet itself.
Use 4xM4 wall screws* to mount
the tablet case to the wall through
the four VESA holes.
* Of your choice, not included.
If using a charging cable:
Place the four 3 mm silicone
dots at the back of the tablet
case in a symmetric pattern
10 mm from the edges.
Pull the cable trough one
of the entry holes before
mounting the screws ensuring
enough cable length for the
tablet itself.
Mounting the BOX IT Premium Tablet Case on standard wall
Mounting the BOX IT Premium Tablet Case on glass plate
4 silicone dots
