02
1.
First task: fit your safety rings
2. Second task: fit the main springs
For safety reasons your clay pigeon trap may be supplied with the main
spring detached. Remove the cable ties carefully to access the spring; place
the washer, hand nut and wing nut carefully to the side. To re
-
attach the
main spring, push the throwing under the main plate and round until it points
straight ahead. In this position there is no tension on the main spring,
allowing you to fit the M12 studding through the spring tension block at the
rear. Once through the block, add the washer, tighten the hand nut to the
desired spring tension and then finally secure with the 12mm wing nut.
3. Third task: fit the clay hoppers
Screw the 10mm studding of the
safety ring into the front of the
casting and lock off with the
10mm nut.
Remove the
‘
R
’
clips from the
sockets underneath the clay plate
at the rear of the trap and insert
the safety ring ends.
Align the holes and secure by
pushing the
‘
R
’
clips through the
socket and safety ring. Finally
lock the two 10mm nuts up to the
steel tube at the front of the
safety ring.
Remove all three 6mm wing
nuts.
Place the hopper with short
ends down onto the three studs
now protruding,
Secure with the wing nuts and
ensure these remain tight
through regular maintenance
checks.
