4
INSTALLING STEPS
Step 8: INSTALLING THE CONSOLE/ HANDLEBAR ASSEMBLY
Locate the following for this step:
PARTS:
TreadClimber® Base & Treadle Assembly from
Step 7.
Console/Handlebar Assembly
HARDWARE:
Six (6) 5/16” x 1” Button Head Screws
Six (6) 5/16” Flat Washers SAE
TOOLS:
3/16” Hex Key (included)
With the help of another person, carefully lift
the console/handlebar assembly above the
tops of the upright supports. Feed the cable
down the top of the right upright support (see
Figure 8-1 & 8-1A). Make sure cable extends
through the bottom of the right upright.
Slide the brackets on the console/handlebar
assembly into the tops of the upright
supports
—
both sides at the same time. Be
careful when sliding the console/handlebar
assembly onto the uprights to avoid damaging
the electrical cable.
Attach the upright using (6) 5/16" x 1" button
head screws and (6) 5/16" flat washers SAE (3
per upright). Tighten with the provided 3/16"
hex key (see Figure 8-2).
Pull out the wire connector at the bottom of
the right upright support. Firmly connect the
electrical cable at the bottom of the right
upright support to the cable on the right side
of the base upright bracket (see Figure 8-3).
Figure 8-1
Figure 8-1A
Figure 8-2
Figure 8-3
