3
INSTALLING STEPS
Step 6: INSTALLING THE UPRIGHTS
Locate the following for this step:
PARTS:
TreadClimber® Base & Treadle Assembly from Step 5.
One (1) Left Upright Support & Hydraulic Cylinder
One (1) Right Upright Support & Hydraulic Cylinder
HARDWARE:
Two (2) 5/16” x 1” Button Head Screws
On the base assembly screw a 5/16" x 1" button head
screw half way in on the outside of both the right and
left lower upright bracket (see Figure 6-1).
Place the left upright onto the left upright bracket
(see Figure 6-2), so it rests on the button head screw
(see Figure 6-3). Make sure the cylinder bracket is at
the top and pointing to rear.
Repeat this process on the right side.
Figure 6-1
Figure 6-2
Step 7: INSTALLING THE UPRIGHT JUNCTION COVERS AND COSMETIC PLUGS
Locate the following for this step:
PARTS:
TreadClimber® Base & Treadle Assembly from
Step 6.
Two (2) Plastic Upright Junction Covers
HARDWARE:
Four (4) Cosmetic Plugs
Place the plastic upright junction covers onto the
top of left upright support (see Figure 7-1).
Insert the cosmetic plugs (2 per side) into the holes
on the top, inside and outside of the left upright
support (see Figure 7-2).
Repeat this process on the right side.
Figure 6-3
Figure 7-1
Figure 7-2
