Bowflex ElitePlus, Assembly Instructions Manual

Page: 17 / 94

A-15
Figure 20
Step 20 - Attach the Faceplate Back Panels
Locate the following items:
• Item #27 - Faceplate Right Back Panels
• Item #28 - Faceplate Left Back Panels
• Item #32 - 100 Pound Power Rod® Unit
• From Step 19 - Main Assembly
• Item #A - (2) #10 Phillips Head Screws
Slide each Faceplate Back Panel (Items #27 & 28), textured
side out, against the textured (back) side of the Faceplate.
The screw heads of the (2) Phillips Head Screws installed
during Step 19 should allow the Back Panels to slide beneath
them until the panels meet in the center..
Secure the Panels using (2) #10 Phillips Head Screws (Item
#A), as shown in
Figure 20
, attaching one side at a time.
Completely tighten hardware installed during
Steps 19 & 20.
Adding the 100 Pound Power Rod® Pack:
Slide the tapered notches of the 100 pound Power Rod® pack
(Item #32) into the open slots on the back of the 310 pound
Power Rod® pack.
Step 21 - Tighten Lower Bolt on the Seat
Bracket
Locate the following items:
• F
rom Step 5 - Seat Assembly (underneath)
Using an Allen Wrench (included) and a combination wrench,
tighten the top nut & bolt on the Seat Assembly (see
Figure
21
). Take care that the Seat Assembly can still freely slide
without resistance along the Seat Rail when you are seated.
Note: The Seat Assembly will have some resistance
when rolling if no one is seated.
Take care not to overtighten hardware from Step 21.
Figure 21
Nut
28
27
A
Main
Assembly
32
Assembly Guide