Bowell BX52, Operator'S Manual

Page: 9 / 59

www.etractorimplements.com
7
SAFETY TRAINING
being knocked off the tractor by low hanging limbs and then being run over by the
wood chipper. Accidents are most likely to occur with machines that are loaned or
rented to someone who has not read the owner’s manual and is not familiar with a
rotary wood chipper.

The rotary wood chipper is designed for use only on tractors with the power take-off
(PTO) turning at
540-RPM .

Install and secure all guards and shields before starting or operating. The wood
chipper tines, driveline guards and tractor, shields should be used and maintained in
good working condition. They should be inspected carefully, at least daily, for missing
or broken chain links, shields, or guards. (Worn items must be replaced at once to
reduce possibility of injury.)

Disengage power takeoff (PTO) and place transmission in neutral before attempting to
start engine.

Many varied objects, such as wire, cable, rope, or chains, can become entangled in
the operating parts of the wood chipper. These items could then swing outside the
housing at greater velocities than the tines. Such a situation is extremely hazardous.
Inspect the cutting area for such objects before working. Remove any like objects from
the site.

Never allow the working tines to contact such items. Never assume an area is clear.
Always Check!

Always stop the tractor, disengage PTO, set brake, shut off the tractor engine, remove
the ignition key, lower implement to the ground and allow rotating pieces to come to a
complete stop before dismounting tractor. Never leave equipment unattended with the
tractor running.

Never place hands or feet under wood chipper with tractor engine running or before
you are sure all motion has stopped. Stay clear of all moving parts.

Do not reach or place any part of your body under equipment until it is blocked
securely.

Do not allow riders on the rotary wood chipper or tractor at anytime. There is no safe
place for