Bouyer DN 3816, Manual

Page: 8 / 23

8
DN3816
5.3 Rear panel
5.3.1 NETWORK connector
These connectors (In et Out) are used to connect the DN3816 matrix to the EtherSound network ; the In
connector is used to receive the incoming EtherSound Stream and the Out connector is used to transmit the
outgoing stream.
5.3.2 CONSOLE connector
The Console 1 and Console 2 RJ45 connectors are used to connect two console buses (GX 3016, GXT 4000)
to the unit.
The Console 2 connector also has an RS232 serial Data Link for connecting an additional control device.
5.3.3 GP Inputs connector block
The GP Inputs block comprises 8 opto-isolated logic inputs.
5.3.4 GP Outputs connector block
The GP Outputs block consists of 16 open-collector logic outputs.
5.3.5 Serial Number label
The label displays the serial number of the DN 3816.
5.3.6 Analog Inputs 1 to 8
The analogue inputs connector strip consists of 8 balanced analogue audio inputs.
5.3.7 Analog Outputs 1 to 16
The analogue outputs connector strip consists of 16 balanced analogue audio outputs.
5.3.8 24 V socket
This socket allows the unit to be powered using a 24V DC direct current supply instead of a 230V AC mains
supply.
5.3.9 MAC address
This information is the MAC address of the DN3816 (used for software settings on application server.
5.3.10 Ground point
Use this connector to ground the DN 3816 matrix to earth when fitting the unit inside a rack cabinet. In certain
circumstances, earthing the unit will considerably reduce hum, noise and interference.
5.3.11 Mains block
The earthed mains block should be used to connect the DN3816 to a suitable 230V AC mains supply using
the lead provided.
5.3.12 ON / OFF switch
The ON/OFF switch on the mains block should be used to power the DN 3816 on and off.