4
Batteries
Your Time Ranger™ metal detector requires two C
ALKALINE
batteries.
Using the following diagram as your guide, follow these easy steps to
install the batteries.
▲
To install the batteries
1. To remove the battery compartment cover, carefully press the release
clip to the right of the cover.
2. Pull out the battery holder and install two C batteries.
3. Slide the battery holder back into the battery compartment.
4. To replace the cover, carefully insert the side opposite the release clip
first and then carefully press down on the other side until the cover
snaps in place.
CAUTION:
Use only fresh batteries of the required size and type. Batteries
must be
ALKALINE
type, such as Energizer C size LR14.
▲
To check the batteries
1. Turn the unit
ON
.
The low battery indicator and all other arrow indicators appear
briefly in the LCD display, indicating that the detector is working
properly and the batteries are good.
2. If the arrow on the
BATT
(battery) dial points to
R
(Replace), replace
the batteries.
NOTE:
Many metal detector problems are caused by weak, dead, or
improperly connected batteries. If the detector does not turn on,
or if it shows signs of weak volume, improper tuning, erratic
operation, or drifting, replace the batteries.
Release
Clip
Release Clip of
Battery Door
C Size Alkaline
Batteries
