Page 13
9e1060
3.3 STORAGE
The following rules must be observed when storing the delivered goods:
Do not store the product outdoors or in areas with chemical vapours, moisture, excessive temperature and/or
dirt.
Do not store the product on the bare floor/ground.
Ensure proper storage of electrical components and/or fragile objects.
Strong exposure by e.g. exposure to sunlight at high humidity influences the appearance of metal parts and
can cause damage to electrical and pneumatic components.
Plastics can change in colour due to excessive UV radiation and, in extreme cases, can become brittle.
3.4 GENERAL ASSEMBLY INSTRUCTIONS
The milking parlour is delivered in individual parts. It must be assembled by trained personnel, taking into account the
contents of this manual.
Installation personnel must have knowledge of the type of installation and possible risks.
The instructions in this manual must be followed. BouMatic accepts no responsibility or warranty for damages resulting
from improper installation and their consequential damage.
The following information must be observed:
During welding operations,
in particular of galvanised parts, harmful gases can lead to damage to health. Avoid
breathing these vapours and ensure adequate ventilation.
Adaptations, e.g. cutting certain parts, requires mechanical expertise.
A bitumen coating shall be applied to all parts to be encased in concrete up to 50 mm (2 “) above the top edge
of the finished concrete.
If possible, use greases approved for the food industry, such as “Unil Opal Polyfood 2” or a comparable lubricant.
Always grease stainless steel screws before mounting..
If you weld galvanised surfaces or galvanised parts mechanically, immediately apply a new zinc coating.
For screw connections, observe the permissible torques (see table on the next page).
