35662-3-0216
Page 53
MAINTENANCE AND SERVICE
Removing the Barrier Screen
Lift the barrier up approximately 1/4in with one hand under the
lower barrier frame edge to disengage the lower flange. Grasp
the top of the barrier and pull forward to disengage it. Remove
the barrier by pulling straight forward.
Removing the Glass Door Assembly
Locate the glass door tool (secured to the top of the fireplace for
shipping). Use the tool as a lever to release the bottom of the
glass door as shown in Figure 97.
Note: The glass door is secured to the top of the firebox with
tabs that allow the glass door to pivot outward at the bottom.
The bottom of the door frame engages into the four bullet type
retainers.
Pivot the glass door out until the bottom of the door is about 6
to 8 inches from the firebox face, then lift upward on the door
assembly to disengage the top of the door from the tab retainers
on top of the firebox. See Figure 97.
CAUTION
The glass door is wide and heavy and can be difficult to install
or remove by a single person. It is recommended that two
people remove the glass door.
GLASS DOOR REMOVAL TOOL
PLACE SMALL 90° END OF THE
GLASS DOOR REMOVAL TOOL
BEHIND THE BOTTOM DOOR
FLANGE, THEN MOVE TOOL
SIDEWAYS TO DISENGAGE
THE RETAINER CLIPS
Figure 97
PIVOT
OUT
TABS
2
LEFT UP TO
RELEASE OFF
THE TABS
GLASS DOOR
ASSEMBLY
FIREPLACE
FACE
1
Figure 98
Wiring
If any of the original wire supplied with this unit must be replaced,
it must be replace with 18 GA. 150°C wire or its equivalent.
Replacing the Light Bulbs
(Bulb Type: 20V 35W 6.35mm Base)
1. Remove the barrier and the glass door assemblies.
2. Lift the light access cover up and out of the firebox.
See
Figure 99.
3. Remove the bulb(s) to be replaced.
See Figure 100.
4. Wear gloves or use a clean cloth while handling bulbs or
bulb lifespan may be decreased.
Figure 99
Figure 100