Bottoms Up Beer BEER BUDDY, Instructions Manual

Page: 39 / 44

15
Cleaning
Important:
Do not use abrasive cleaning agents.
We recommend using a commercially available detergent diluted in an appro-
priate quantity of water. Use the proportions recommended on your detergent
packaging.
Remove the drip plate and the drip tray.
Lift the keg and dispenser out of the container and place them on a secure, flat
surface.
The container, drip tray and drip plate can now be flushed out and washed up,
or wiped out and wiped off as needed.
To remove more stubborn marks, you can safely use hot water. All foam parts are
heat-resistant up to 100°C.
Naturally, this also applies to the stainless steel components.
If you wish to clean the Beer Buddy, but the keg is not yet empty, we recom-
mend you leave the dispenser attached to the keg and wipe both with a damp
cloth.
When your keg is empty, follow the instructions under ‘Changing the Keg’ to
remove it. Then you can wipe the dispenser down with a damp cloth.
You can also clean inside the dispenser by holding it upside down with the
tapper under running water while holding the dispensing valve open with your
hand.
The dispensing valve (the upper black component) can also be removed for
cleaning. However, we recommend you only carry this out before long periods
of disuse, or after intensive use.
Important:
To prevent mould growth, allow all parts to dry thoroughly after cleaning, befo-
re reassembling your Buddy.