15
l
LNB Frequency
: Press OK button to see the frequency list given and select the
proper frequency according to the current LNB being used for the selected satellite.
You can also enter the frequency by using the numeric keys of RCU.
l
DiSEqC 1.0 selection
: Press OK key to display the list and choose the proper
selection for your DiSEqC switch.
l
Transponder
: Press OK button to view the transponders list of the selected satellite
then again use OK button to select the desired one. If the desired TP frequency is not
shown in the given list, then press GREEN button to go to SAT/TP Edit menu and
edit a new TP frequency.
Refer to SAT/TP Edit menu for further details.
l
Network Search
: Some of the new transponders being broadcasted in the satellite
could be missing in the given TP list. In this case, there is a good chance that the
information of those new transponders are being sent through
the given TP. So, if you set the Network Search to 'ON' status and search that TP,
then you will be able to catch the channels in those new transponders.
l
FTA/Scrambled
: Select 'FTA Only' to search the Free To Air channels only. Otherwise,
select 'ALL' to perform the search for all the enc FTA channels.
l
Start Searching
: If all of the above parameters are set correctly, you will be able to
see both of the
Signal (RED bar) and Quality (Green bar) level
at the bottom of the
menu. Now, press OK button(Blue key) to start searching.
