Botanicare SLIDE BENCH, Assembly Instructions Manual

Page: 3 / 30

Page | 3 Technical Support 1-888-808-4826
Tools Needed
The following tools & supplies are required to complete this assembly of the slide bench.
•
Cordless Drill with clutch
• Hammer Drill
•
Tape Measure
•
String Line or Layout Laser
•
Chalk Line
•
Level
•
Hammer or Mallet
•
Combination Wrench or 15/16” Box
Wrench
•
3/8” Magnetic Nut Driver Drill Bit
• 5/16” Magnetic Nut Driver Drill Bit
•
¼” Masonry Drill Bit
•
Rubbing Alcohol
•
Clean Cloth Rags
•
Caulk Gun
•
1 3/8” Step Drill Bit
Anchors Not Included
Installation of the bench systems will require ¼” x 2¼” wedge style concrete anchors.
Installation of the anchors should follow the anchor manufacturer’s recommendations.
Acceptable wedge style anchor
Setting the Drill Clutch
CAUTION: Overtightening screws using a drill can result in stripping the threads in aluminum
parts.
•
Every drill is different, use caution until familiarity with the drills capabilities.
•
Use the lowest setting on the drill clutch that will install the screws.
• A higher torque may be required to initially cut the threads, reduce torque for final
tightening.
•
After installing, hand tightening will help prevent stripping threads.
NOTE: There is a repair kit available should a screw strip out a hole.