34
Section 7 - Livewell System
320 Outrage-Owner’s Manual
Livewell
The 320 Outrage is equipped with an
45 Gal. (170L)livewell bucket that is
located aft of the helm pilot seat. The
livewell system’s primary function is
to keep baitfish alive by circulating
seawater into the livewell bucket. The raw water
pump, seacocks and plumbing that service the sys-
tem can be reached through the access doors located
on the aft wall inside the console. Fittings connected
to the livewell bucket and the livewell flow control
valve can be reached through an access panel located
on the starboard side of the prep station base.
OPERATION:
The livewell can be filled by using the switch marked
“LIVEWELL” on the instrument panel. Before fill-
ing the livewell, you must make certain the hull
seacock and the livewell flow control valve are in
the open position. The livewell also has a pair of
drain plugs that are used to adjust the amount of wa-
ter that stays in the livewell. There is a plug that will
drain the entire livewell located in the base of the
livewell, the other plug can be used between the two
overflow fittings on the starboard side of the livewell,
they can be used to adjust the level of water in the
livewell.
1
Livewell, 45 gal. (170.3L)
2
Livewell Bucket Upper Overflow
3
Livewell Bucket Lower Overflow
4
Livewell Light
5
Livewell Fill
6
1.5 inch, “Y” Coupling
7
1.5 inch, “T” Coupling
8
Flow Control Valve
9
12V/1100 GPH Raw Water Pump
10
Raw Water Pump Seacock
11
Sink Drain Hose
12
1 inch to 1.5 inch “T” Coupling
13
To Drain Fitting on Transom
14
Livewell Tank Drain Plugs, (There are two plugs
to control the level of water in the livewell).
15
Twist-out access plate to flow control valve
Standard Livewell System Diagram
The livewell seacock located behind the lower doors
in the aft section of the console interior, must be in the
OPEN position before using the livewell. Damage to
the pump could occur if it is closed when operating.
NOTICE
!
1
2
3
4
5
6
7
8
9
10
11
12
13
View of raw water pump
looking aft
Flow Control Valve:
The flow control valve does exactly that, it allows
you to control the flow of water into the tank. access
to the flow control valve is from the twist out plate
on the starboard side of the prep station base.
MAINTENANCE:
Maintenance of the livewell system will require pe-
riodic inspection of the raw water intake strainer,
(when boat is in drydock). All connections from the
hull to the livewell need to be checked for tightness.
14
15
Shown in
“ON” position
