Boston Whaler 235 Conquest, Manual

Page: 34 / 82

2-6
235 Conquest
Section 2 • General Information
R
Through Hull Fittings, Port
Fig. 2.6.1
Through Hull Fittings, Starboard
Fig. 2.6.2
Through Hull Fittings, Stern
Fig. 2.6.3
1
2
3
1
2
3
LIVEWELL DRAIN
PORT FISHBOX PUMP OUTLET
AFT BILGE PUMP OUTLET
1
2
3
ANCHOR LOCKER DRAIN
FORWARD BILGE PUMP OUTLET
WASTE SYSTEM VENT
STARBOARD FISHBOX PUMP OUTLET
4
1
2
3
4
1
2
3
4
5
6
1
2
3
4
1
2
3
4
5
6
Through Hull Fittings, Aft
Fig. 2.6.4
1
2
3
4
STARBOARD FISHWELL DRAIN
OVERBOARD WASTE DISCHARGE
LIVEWELL INLET
PORT FISHWELL DRAIN
PORT DECK DRAIN
PORT MOTORWELL DRAIN
GARBOARD DRAIN
STORAGE COMPARTMENT DRAIN
STARBOARD MOTORWELL DRAIN
STARBOARD DECK DRAIN
NOTICE
•
The deck drain provides self-bailing capabilities while the boat is static in the water and no passengers on board.
This feature prevents the accumulation of water in the cockpit. the drain plug must be in place when underway.
•
Depending on the type of boat you have, you may have underwater fittings that need drain plugs. Garboard drain plugs
and fishbox drain plugs need to be in place before the boat goes into the water. Any fitting that will be underwater
needs to be plugged or the seacock needs to be closed
•
Through hull fittings should be checked for proper seal annually. When the boat is in the water the underwater fittings
can be checked for dripping. It is recommended that the underwater fittings be removed, cleaned and resealed every
other year.
•
If the through hull fittings need to be replaced, it is recommended that an authorized Boston Whaler ® dealer perform
this type of repair. Through hull fittings that are improperly installed can cause premature hull failure and may void
the Boston Whaler
® limited warranty.
Location of Thru-Hull Fittings
•
A standard 1” “Snap-Tite” plug can be used to replace the drain plug(s) in your boat. It is recommended that you
carry spare plugs to be used in the event that the drain plug(s) become lost or damaged.