Changing Cutting Blade
WARNING!
Improper handling of blade may cause physical harm.
•
When changing the blade, remove power cord from receptacle. Remove the 4 wing nuts on the periphery of the guard
and remove the right side of guard to expose the blade and spindle. Press the spindle lock located above the plastic eye
shield and rotate the blade until it is in the locked position. Place hex wrench onto the arbor bolt and unscrew the bolt.
CAREFULLY remove the blade. Reassemble by replacing the blade, flange, arbor bolt assembly and cover.
For blade sharpening and manufacturer replacement items, contact: Hudson Supply Co.
Cleveland, OH
Department: Blade Service Center
(216) 518-3000
Hose Cutting Machine Manufacturer Replacement Parts List:
Contact Hudson Supply for these five manufacturer’s replacement parts.
•
Carbon motor brushes
•
Handle and trigger switch
•
Eye Guard Goggles (clear)
•
6” long - hose support dowel pin (black oxide coated)
•
Reorder & Optional Parts List supplied by Boston Weatherhead:
PART NO. DESCRIPTION
T-70-DP
Set of 4 - 6” long - hose support dowel pins (black oxide coated).
T-1070
14 inch steel scalloped blade.
T-1071
Optional
14 inch steel scalloped toothed blade.
T-1072
Optional
14 inch steel smooth beveled blade.
Hose Support Pins
•
Hose support pins should always be completely screwed in against the faceplate of the cutting machine. To achieve a
square cut, place hose on the pins making sure that they are equally aligned. Place the hose to be cut over the two
center support pins and apply downward pressure on the ends of the hose, not exceeding the hose’s minimum bend
radius. See Hose Assembly Master Catalog for minimum bend radius information. Screw the two outside support pins
into the corresponding holes that allow for the correct arc. Always create a firm arc to facilitate the ends of the hose
bending away from the blade as it cuts the hose.
