8
Connecting Your Subwoofer to Stereo or Dolby
®
Pro Logic
®
Systems
For stereo or Dolby Pro Logic systems, the easiest method is to use speaker wire
connections as shown.
You may also use the “sub out” connection from your receiver to the input on the subwoofer
marked
use crossover control.
When using speaker wire or the
use crossover control
input, the subwoofer’s built-in crossover is
engaged. As a starting point, set the crossover control on the subwoofer about 10Hz higher than
the lower limit of your main speakers’ bass response. Fine-tune the crossover setting by ear for
the smoothest blend with your main speakers. The best setting of the crossover control will
depend on speaker placement and personal preference.
BACK OF RECEIVER
3.0A 250V
CAUTION:
Disconnect supply cord before replacing fuse. For continued protection
against risk of fire, replace only with same type fuse.
ATTENTION:
Debrancher avant de remplacer le fusible. Utiliser un fusible de
rechange de même type.
120V 60Hz 3.0A
0
°
180
°
polarity
on
power
off
auto
50
80
150
120
left
right
speaker level in
crossover (Hz)
use
crossover
control *
bypass
crossover
control **
line level in
* use crossover control
:
removes high frequencies; use with sources lacking
suitable filtering (most products without Dolby Digital or THX), or where manual
control is desired.
** bypass crossover control: direct to woofer; use with sources having built-
in crossover controls or bass management (most products with Dolby Digital
or THX).
subwoofer out
BACK OF RECEIVER
PV800
REAR PANEL
PV 4/6/8 MANUAL 7.1.99 ƒ 7/30/99 4:01 PM Page 8
