Step Three: Mounting the Bravo Speaker
1.
Using the speaker screws (long), washer,
and
1
⁄
4
"-20 threaded nut, mount the
Bravo mounting bracket to the P4TS
post.
2.
Remove the speaker’s grille by grasping
the back of the cabinet in one hand,
while gently pulling the grille away with
the other hand.
3.
Connect the speaker wire to the
terminals on the Bravo speaker.
4.
Align the openings in the back of the speaker with the two
posts protruding from the bracket as shown and attach the
speaker to the bracket by inserting the supplied screws
through the holes in the front of the speaker and into the
bracket as shown. Insert the plug into the unused machined
hole on the post.
Note: For detailed instructions on installing the
speaker to the wall bracket, please refer to the Bravo owners manual.
4.
Take up any slack in the speaker wire by
gently
pulling the wire
at the opening in the base.
Bravo Vertical Mount Assembly Instructions:
This configuration is compatible with Models: Bravo II
and Bravo.
Hardware / Parts:
Required Tools:
Speaker
Screw
(long) x 2
Threaded
Machine
Screw x 3
P4TS
Base x 1
P4TS
Vertical
Post x 1
Step Two: Speaker Wire
With the stand still inverted, route
the speaker wire through the
opening in bottom of the base,
down through, and out the slot in
the opening near the top of the
post. Leave several extra inches of
speaker wire exposed to ease
connection with the Bravo speaker.
Step One: Attach Base
Attach the base to the vertical
post with the three included
threaded machine screws and
split washers (small) using a
Phillips head screwdriver. The
post has already been threaded
to ease screw installation. Attach
rubber feet to base.
•Pliers
•Flat head
Screwdriver
•Phillips head
Screwdriver
Split
Washer
(large)
x 2
1
⁄
4
"-20
Threaded
Nut x 2
Split
Washer
(small)
x 3
Plug
x 1
