7
4.2 Installation
Installation step 1
Installation step 2
Installation Steps:
1: Use percussion drill to make four Φ7 holes on the wall according to above
hole diagram, fasten the
Expanding plug
onto the wall.
2: Screw up repeater to the wall.
4.3 Connection
Connection of RF cable
BTS port connect with the outdoor antenna , put antenna on the place where
there is strong signal, then connect to MS port of equipment and assure good
connection.
Grounding connection
Use earth wire to link the repeater grounding port with building grounding system.
Power resistance must be less than 10 Ohm
Power supply connection
Please use three-pin plug to assure good grounding
Chapter 5 Repeater setting
Please check whether the connection of RF cable is correct (donor antenna connected