MAINTENANCE AND REPAIRS
Premise: Continuous and extended use in time and the properties of the water
supplied from the water grid (calcium/impurities), may cause efficiency loss of
the thermostatic cartridge. Maintenance/cleaning or full replacement may be
necessary.
Proceed as follows:
- Close all water supplies to single lever mixer;
- Open the faucet by engaging the supply/mixer lever (6) and drain the water in the pipes
upstream from the mixer.
- Remove the cap (7), unscrew the grub screw (8); remove the supply/mixer lever (6);
(Fig 11).
- Remove the wall trim (4) to avoid scratching when at work; unscrew the lock nut cover
(5) and the lock nut (3). (Fig.12)
- It is advised that the contact between the wrench, the lock nut (3) and lock nut cover (5)
be protected when fastening and locking into place.
- Remove the mixer cartridge (2) and remove any residue or deposits that have formed in
the seat.
- Insert the new cartridge mixer (2). Be sure that the studs at its base are lodged into their
seats.
- Screw in the lock nut (3) and lock into place.
- Mount wall trim (4) (Fig 15);
- Screw in the nut lock nut cover (5) and mount the supply/mixer lever (7).
- Fasten with the grub screw (8) and seal with the cap (7) (Fig. 15).
- Use a rag to clean thoroughly (Fig. 16).
Note: If performing maintenance, submerge the cartridges in a water-vinegar
solution (50%+50%) for about 12 hours, thereby facilitating removal of impurities
and calcium.
CLEANING
Dear Customer,
To keep the material’s appearance as long as possible, a few guidelines must be followed.
Cleaning metal parts:
water contains calcium that deposits on surfaces and forms
unpleasant spots. For routine cleaning,simply use a damp cloth with a little soap, rinse and
dry. Calcium spots can therefore be avoided by drying after use.
Important note:
Using only a soap-based detergent is recommended. Never use abrasive
detergents or disinfectants or those containing alcohol, hydrochloric acid or phosphoric
acid.
Dear Customer, we would like to remind you that the warranty on our product’s surface is
not valid if the material undergoes treatment different than that suggested.
The warranty
does not cover any damage due to deposits of calcium or impurities.
WARRANTY TERMS
Dear Customer,
We congratulate you and thank you for choosing a Bossini quality product
GB
14
MONOCOMANDO 1 VIA
