bossauto SHA56, Operation Instruction Manual

Page: 13 / 16

-11-
LEVER RESET PROCEDURE
The reset procedure will be needed when sander operates abnormally or a�er
maintenance.
1.Switch off the power.
2.Press and hold down the “ + “ bu�on. Then plug-in the power cord.
(Figura 1)
Press the “—“ bu�on for 5 �mes
(Figura 2)
and the tool now enters the reset mode.
3.Ensure to release the lever
(Figura 3)
and “ + ” bu�on.
Wait for the LED flash “ red ”color two �mes
(Figura 4)
.
4.Press the speed lever firmly
(Figura 5)
and wait for the LED flash “ red ” color quickly
(Figura 6)
,
then release the speed lever immediately
(Figura 7)
.
Wait for the red light goes out
(Figura 8)
,
the reset procedure is finished.
Op�onal Accessory
Connector/Φ25mm
Figura
1
Figura
4
Figura
6
Figura
8
Figura
2
Figura
3
Figura
7
Figura
5