Boss SNR24023, Owner'S Manual

Page: 5 / 12

Setup
Mounting the Plow
1. Park the machine on a level surface.
2. Pull the coupler pins outward and rotate 90° to
lock in the disengaged position.
g373475
Figure 3
3. Make sure that the hydraulic hoses do not block
the plow attachment point.
4. Start the machine.
5. Slowly drive forward until the coupler meets the
plow hooks. Raise the coupler to hook it onto
the plow.
g381690
Figure 4
6. Rotate the coupler pin 90° so that it engages
with the plow assembly.
Note:
Ensure that the coupler pin also inserts
through the hole in the pin channel on the plow
coupler.
g373477
Figure 5
7. Lower the attachment coupler until the plow
rests on the ground.
8. Shut off the machine engine, wait for all moving
parts to stop, ensure that the parking brake is
engaged, and remove the key.
9. Route the hydraulic hoses from the plow,
through the hose strap, to the connections on
the machine
Note:
The left low flow hoses are colored yellow
and connect to the center ports.
g381686
Figure 6
10. Start the machine.
5