Patch:SimulStart
—In Multi mode, there may be instances where you’d
like two or more phrases to start playing simultaneously when you
press the REC/PLAY/OVERDUB pedal, or when the patch is selected
during phrase playback. This can be achieved using the Simul-Start
function.
1BUDI4JNVM4UBSU
0''0''0''
While on this screen, you can select the Simul-Start status for each
phrase: Use the parameter buttons to select the desired phrase, and
then turn the PATCH/VALUE dial to choose the desired setting (ON or
OFF).
Simul-Start settings have no effect when the RC-50’s in Single mode.
To learn more about Simul-Start, see the RC-50 Workshop booklet
Using
Multi Mode and
Page 50 in the
RC-50 Owner’s Manual
.
You can also turn on Simul-Start for a phrase by pressing and holding
its PHRASE SELECT pedal for at least two seconds. When Simul-Start is
already on, you can turn it off using the same procedure.
In Multi mode, you can start and stop all phrases at once by
simultaneously pressing both the PHRASE 2 and PHRASE 3 pedals.
Patch:Input Out
—This parameter determines the output pair (or pairs)—
MAIN, SUB, or MAIN+SUB—used to output sounds arriving at the
RC-50’s INPUT jacks.
Sounds assigned to the MAIN outputs are also sent to the PHONES
jack.
•
•
The RC-50 has system input settings that allow you to override the
settings made in a patch. When they’re set this way, changes made on
the Patch:Input Out screen won’t have any effect. To learn more about
system input settings, see the RC-50 Workshop booklet
Audio Inputs
and Outputs
and Page 69 in the
RC-50 Owner’s Manual
.
Patch:MIDI Sync
—This parameter determines how the RC-50 behaves
when receiving MIDI synchronization messages from an external
device. The available settings are AUTO, INTERNAL, or REMOTE. To learn
about these settings, see Page 50 in the
RC-50 Owner’s Manual
.
Phrase Settings
There are a number of settings that determine the behavior of individual
phrases within the patch. These settings are made on the phrases’ Phrase
Edit screens:
Press the PHRASE EDIT button for the desired phrase: PHRASE 1, 2, or
3.
Use the PARAMETER buttons to display the desired Phrase Edit screen
for the selected phrase.
1ISBTF0OF4IPU
-001
In this example we’ve selected Phrase 2’s One Shot screen.
Turn the PATCH/VALUE dial to choose the desired setting.
Repeat Steps 2-3 to make additional settings. (While you’re on any
Phrase Edit screen, you can select a different phrase by pressing its
PHRASE EDIT button.)
Press EXIT when you’re done.
•
�
�
�
�
5�