Boss Snowplow STB08980, Installation Instructions Manual, Page: 19 / 36

SmartTouch2 Controller
The SmartTouch2 controller operates the movement
of the snowplow.
Note:
Plows equipped with D-Force must have a
SmartTouch2 controller with a red center button.
g032938
Figure 32
1. L
OWER
button 4. O
N
/O
FF
switch
2. L
EFT
button 5. R
IGHT
button
3. R
AISE
button
•
O
N
/O
FF
switch—turns the plow controller on and
off. A green light illuminates when the controller
is on.
Note:
Turn off the controller when not in use to
prevent accidental activation of the plow.
•
R
AISE
button—raises the plow blade. Pressing the
button quickly twice automatically raises the blade.
•
L
OWER
button—lowers the plow blade and
activates the F
LOAT
and D-F
ORCE
features.
– F
LOAT
—double tapping the button automatically
lowers the blade and activates the F
LOAT
feature, allowing the plow blade to follow the
contour of the ground. A red light illuminates
when the F
LOAT
feature is active.
– D-F
ORCE
(optional)—if your plow is equipped
with the D-F
ORCE
feature, double tapping the
button a second time activates it, applying a
downward force on the blade to improve back
blading. An orange light illuminates when the
D-F
ORCE
feature is active.
Note:
The D-F
ORCE
feature can only be
activated twice before the plow must be raised.
•
L
EFT
button—angles the plow blade to the left
•
R
IGHT
button—angles the plow blade to the right
•
Sleep mode—If you do not use the controller for
20 minutes, it enters sleep mode and the controller
lights flash green and red. Turn the controller off
to deactivate the sleep mode.
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Mounting the Snowplow
Note:
The vehicle must be running before starting
this procedure.
1. Activate the F
LOAT
feature on your plow
controller.
2. Line up the vehicle with the snowplow and
slowly drive forward until the lower pin contacts
the push-beam pin receiver (
Figure 33 ).
g032911
Figure 33
1. Plow wire harness 4. Lower pin
2. Vehicle wire harness 5. Pin receiver
3. Coupler
3. Turn the levers on the couplers to the O
N
position ( Figure 34 ).
g032941
Figure 34
1. Coupler tower 3. Coupler spring-pin
2. Pin receiver 4. Coupler lever
4. Remove the electrical-plug dust-covers and
connect the plow wire harness to the vehicle
wire harness (
Figure 33 ).
19